Stick Instructions for Betaflight, iNav, and HDZero OSD Menu

For FPV pilots, stick instructions are a necessary instrument for altering settings of your flight controller or FPV system instantly out of your radio. These instructions assist you to carry out varied capabilities, from navigating the OSD menu to trimming accelerometer, making them invaluable if you’re within the subject with out entry to a pc. I’ll share the the stick instructions diagrams for Betaflight, iNav, and HDZero, so that you don’t need to memorize them.

Among the hyperlinks on this web page are affiliate hyperlinks. I obtain a fee (at no further value to you) for those who make a purchase order after clicking on one among these affiliate hyperlinks. This helps assist the free content material for the neighborhood on this web site. Please learn our Affiliate Hyperlink Coverage for extra data.

What Are Stick Instructions?

Stick instructions are particular mixtures of joystick actions in your radio that ship instructions to the flight controller (FC), enabling sure capabilities or activating the OSD menu.

Word: All stick command diagrams on this information use Mode 2, the preferred radio configuration. If you happen to use a unique mode, you’ll want to regulate the diagrams accordingly.

What’s Mode 2?
In Mode 2, the left stick controls throttle and yaw, whereas the proper stick controls pitch and roll. Be taught in regards to the fundamentals of radio right here: https://oscarliang.com/radio-transmitter/#Modes

Betaflight Stick Instructions

Essentially the most generally used Betaflight stick instructions embrace:

• Enter OSD Menu: Maintain yaw left and pitch ahead.
• Accelerometer (ACC) Calibration: Maintain throttle up, yaw left, and pitch backward. That is helpful for those who can not carry out ACC calibration on a bench utilizing the configurator.
• Trim ACC: Use the 4 ACC trim instructions to regulate errors within the accelerometer. That is significantly helpful in case your quad drifts in Angle or Horizon mode or for those who calibrated the ACC on an uneven floor.

Professional Tip: Guarantee you’ve full stick journey to entry these instructions. Your stick endpoints ought to ideally be at 1000 and 2000, with the middle at 1500. If for no matter cause you possibly can’t get to those numbers, Betaflight means that you can change these values within the Receiver tab, simply modify the “Stick Low,” “Stick Middle,” and “Stick Excessive”. However for most individuals the default values ought to work wonderful and don’t want altering.

iNav Stick Instructions

Most iNav stick instructions are just like Betaflight’s since each tasks originated from Cleanflight. Nevertheless, iNav introduces further instructions for navigation-focused capabilities:

• Load and Save Waypoint Missions: Distinctive to iNav, these instructions allow you to load or save pre-planned missions by way of the OSD menu with no need a pc.
• Compass Calibration: Throttle down, yaw proper, and roll left. You may use this command extra typically in iNav than Betaflight, particularly earlier than GPS-assisted flights to make sure correct navigation.

HDZero Stick Instructions

HDZero FPV system features a collection of stick instructions for its video and OSD menu. These embrace:

• Enter the HDZero OSD Menu: Entry and modify settings particular to HDZero.
• Video Output Mode Change: Swap output modes to regulate show preferences.

Conclusion: Why Stick Instructions Matter

Utilizing stick instructions in Betaflight, INAV, and HDZero unlocks a degree of comfort and management that enhances your total flight expertise. These instructions enable for fast tweaks with no need a pc, making them important within the subject.